Flower Cookie Cutters

by ueda · Other House Models

70 Downloads

38 Likes

37 Makes

A variety of flower cookie cutters, right on time for spring! The cookie cutters are designed for thinner doughs of 4-6mm thickness. Some shapes are more difficult to get a good imprint of than others. Make sure to cover the cutter side with flour and roll your dough onto flour or a different non-stick surface. The dough should also not be too wet, sind that will make it way harder to get the dough ot without damage. If the dough is stuck, try tapping the cutter from the upper side repeatedly (maybe with some force), until the cut cookie comes out. Print from PETG for it to be cleanable with hand warm water. Clean thouroughly after each use as FDM prints are prone to bacteria! Not dishwasher safe (max 60°C!