Thingiverse
Flower Pot
von Robbel2005
9
Downloads
10
Likes
0
Makes
I made this flower pot in Fusion 360. I'm learning fusion 360 on my own.
You can print this without supports. I didn't use vase mode, because I wanted the walls 2mm.
I printed in Petg, at 238 degrees hotend and 70 bed at 50 mm/sec.
On top it is 14 cm wide.
You can print this without supports. I didn't use vase mode, because I wanted the walls 2mm.
I printed in Petg, at 238 degrees hotend and 70 bed at 50 mm/sec.
On top it is 14 cm wide.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
