Thingiverse
Flower pot
von Origzero
0
Downloads
1
Likes
0
Makes
Pot is 11,7cm x 11,5cm and saucer is 12,5cm x 1,5cm.
There is also a model without the hole at the bottom, incase that suits better for your needs.
You can print the little stands included in the files and glue them to the bottom of the pot to raise it a little.
Printed with PLA with 10% infill, and to be on the safe side I used treelike supports for the pot, but not really sure if that is actually necessary.
There is also a model without the hole at the bottom, incase that suits better for your needs.
You can print the little stands included in the files and glue them to the bottom of the pot to raise it a little.
Printed with PLA with 10% infill, and to be on the safe side I used treelike supports for the pot, but not really sure if that is actually necessary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
