Flowerpot Olaf Snowman

Olaf the Snowman made from plantpots I designed this model in Fusion360, and it was my first go at embossing an stl onto a conical surface. I made separate print profiles for single or multicolour prints. I would recommend the single colour version and painting it if you can as it takes more than 3 times as long to print them in colour and uses significantly more filament. The screw threads on the legs and the connectors are quite a tight fit, I had to work them backwards and forwards to loosen them a bit, but they did go together well. When I printed the multicolour version I had the flushing volume set to 0.6 - you can probably see that the head is quite grey on that version so I have reset the flushing volume to 1.0 in the published profile. Assembly:I glued the head and body parts together, making sure the hole was perfectly lined up as the part named Olaf Hair Base fits there quite snug-ly. Then I pushed the Olaf Hair Base into the hole and screwed the leg connector to it inside t