Thingiverse
Flowerpot Riser to Allow Drainage
di cmooney3
13
Download
18
Likes
0
Makes
This thing is a little "riser" that you can put under a flowerpot to make sure it has good drainage. I have a few pots that have bottoms that are too flat and end up plugging their own drainage holes, so this was my solution.
Basically, you can just print one of these and set your pot on top of it, and water can flow freely through it. The riser has little channels through the bottom to allow water to flow between the sections, so you shouldn't have any drainage issues.
Basically, you can just print one of these and set your pot on top of it, and water can flow freely through it. The riser has little channels through the bottom to allow water to flow between the sections, so you shouldn't have any drainage issues.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
