Thingiverse
FlowerTreeClip
2
Downloads
2
Likes
0
Makes
The FlowerTreeClip allows you to put flowers in your Easter Tree.
You need to set the height to 1mm for an optimal build and adjust the X,Y sizing depending on the thickness of the branch.
You should also use flex PLA to print this.
Created by Wim Van Raemdonck
Co-designer Filip Smets ([District Three](https://www.districtthree.be))
You need to set the height to 1mm for an optimal build and adjust the X,Y sizing depending on the thickness of the branch.
You should also use flex PLA to print this.
Created by Wim Van Raemdonck
Co-designer Filip Smets ([District Three](https://www.districtthree.be))
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
