Floydberg (v0.92)

I made a body as close as I could to strandberg 6 string guitar, and adapted it for a floyd rose bridge. So I named it Floydberg. 1d 9h of print time For a complete build, you will need: ~1.250 kg of filament (I used PLA+, also recommend PETG) 8x 3mm heat set inserts 8x m3 x 16mm bolts 2x humbuckers 2x potentiometers (I recommend just using 2x b500k, a500k are unpredictable) 2x knobs for said potentiometers (OR print your own) 3-way switch (or 5-way with 24 pins, depending on your electronics goals) 6.5 output jack Bridge: Wilkinson WODL1 is recommended for accessability, build quality and exellent tremolo arm. Neck: I used JSZ used neck from Aliexpress for reverse truss rod neck. I also added a version of body without the cutout for reverse truss rod if needed. Bridge posts installed by heating them with blow torch and press fitting inside. Images show previous revision. Since it I made a lot of improvements. + I printed it (on A1!) with gyroid infill of 70% core and wings at 50%, but