Thingiverse
FLSUN Cube LED Strip Mount
di jhickey270
21
Download
10
Likes
0
Makes
I don't have great light coverage around my printer. Most often, I watch the first few layers to make sure everything's working correctly, but I must have my flashlight out to see more detail. I made this LED mount to hold a flexible strip of LED lights for the FLSUN Cube. The mount is tilted and curved slightly to provide better light coverage of the print bed. It attaches between the two pieces of angled aluminum used to support the print bed.
I have also included a clip-on switch holder and cap. I just used the little test switch that came with the LED strip I purchased. The holder can clip to the side of the printer---to the extruded aluminum frame. The cap can be twisted to hold the switch in the "on" position.
The LED strip I used was the Alpena Flex LED 24" White, which I bought at Walmart for ~$18 in the automotive aisle. I wired it up to the 12V power source.
The parts are small and flimsy, but it does make installation easier since they have quite a bit of
I have also included a clip-on switch holder and cap. I just used the little test switch that came with the LED strip I purchased. The holder can clip to the side of the printer---to the extruded aluminum frame. The cap can be twisted to hold the switch in the "on" position.
The LED strip I used was the Alpena Flex LED 24" White, which I bought at Walmart for ~$18 in the automotive aisle. I wired it up to the 12V power source.
The parts are small and flimsy, but it does make installation easier since they have quite a bit of
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
