Thingiverse
Flsun Kossel Plexiglass Enclosure
by Xlemos
61
Downloads
33
Likes
0
Makes
This is the enclosure I designed for my Flsun delta printer
(or any other with 680mm vertical 2020 extrusions).
It uses 9 printed corners and three plexiglass panels, the front panel is hold with magnets.
Each corner is hold with 2 M5x30mm screws.
The two rear panels are hold with 24 M3x12mm screws.
The front panel is hold with 6 10mm x 3mm magnets.
Print: 3x corner back, 4x corner front, 1x corner front bottom R, 1x corner front bottom L.
(or any other with 680mm vertical 2020 extrusions).
It uses 9 printed corners and three plexiglass panels, the front panel is hold with magnets.
Each corner is hold with 2 M5x30mm screws.
The two rear panels are hold with 24 M3x12mm screws.
The front panel is hold with 6 10mm x 3mm magnets.
Print: 3x corner back, 4x corner front, 1x corner front bottom R, 1x corner front bottom L.
Xlemos also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
