Thingiverse
FLSUN SuperRacer (SR) Runout Sensor Bracket
door BENgineering3D
47
Downloads
26
Likes
0
Makes
Thing is a runout sensor bracket to mount the factory sensor in middle of the printer. I have a direct drive setup and didn't need it mounted on the side. I will be enclosing my printer at some point so this in a two fold upgrade.
Only part you need in a m6 nut, the rest of the parts you have left over; 4mm bowden fitting, short section of bowden tube, two screws that hold the bracket you removed.
This is compact and the sensor gets locked in place once everything is bolted together.
Only part you need in a m6 nut, the rest of the parts you have left over; 4mm bowden fitting, short section of bowden tube, two screws that hold the bracket you removed.
This is compact and the sensor gets locked in place once everything is bolted together.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
