Thingiverse
FluidNC laser/CNC controller board
door f2knpw
4
Downloads
2
Likes
0
Makes
This board is mainly an IO board allowing:
- to control 3 stepper motors (see later)
- to detect 3 independant home switches
- to apply PWM to the laser controller (see later)
- to detect interlock door switches
- to drive 4x220V relays for air assist, vacuum pump, water cooling and light
- to read 3 more inputs
It is controlled by FluidNC / GRBL firmware
It's part of an open source open hardware project to retrofit an old Trotec laser engraver
Project is here : https://hackaday.io/project/193893-retrofitting-an-old-laser-engraver
PCB can be found on PCBWay shared projects : https://www.pcbway.com/project/shareproject/FluidNC_laser_controller_board_70101fd4.html
- to control 3 stepper motors (see later)
- to detect 3 independant home switches
- to apply PWM to the laser controller (see later)
- to detect interlock door switches
- to drive 4x220V relays for air assist, vacuum pump, water cooling and light
- to read 3 more inputs
It is controlled by FluidNC / GRBL firmware
It's part of an open source open hardware project to retrofit an old Trotec laser engraver
Project is here : https://hackaday.io/project/193893-retrofitting-an-old-laser-engraver
PCB can be found on PCBWay shared projects : https://www.pcbway.com/project/shareproject/FluidNC_laser_controller_board_70101fd4.html
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
