Fluke 73 Multimeter case and stand

I needed a case and stand for my Fluke 73 and I found a 3d Model by Chris Bourgeois:
https://www.3dcontentcentral.com/download-model.aspx?catalogid=171&id=92792

I hollowed it out, split it in too, put screw holed (3mm Brass inserts See https://www.amazon.com/M3-0-5-Brass-Threaded-Inserts-Printing/dp/B07NQL6J1Y )
The brass inserts I uses measure 3.8mm tall and 5.6mm in diameter.


I'm including the STEP ad Fusion 360 file too.

This will probably fit Fluke 7X and 2X series I and II.

Note: Sanding may be required for the hinge on the stand and for the grips on the probe too. I printed in PLA and I hade to sand them to get a good fit.