Thingiverse
Fly swatter
1
Downloads
2
Likes
0
Makes
Fly swatter, optimized for printing without the need for supports on any part, but gluing will be required for assembly:
=> The 'Feet' to the 'Base for Feet.'
=> The 'Holder for the Circuit Box' to the 'Circuit Box.' Be cautious during this step, as one of the pillars is hollow to allow wire passage, and the box has a compatible hole.
=> The 'LED Box' to the 'Circuit Box.' I recommend doing this assembly after installing the LEDs.
I do not recommend gluing other parts; this will allow for maintenance and cleaning.
The design is compatible with a 92mm fan.
The design wasn't intended to be hung, but I've had positive experiences tying fishing lines to the feet and interweaving them with the pillars of the 'Holder for the Circuit Box.'
The feet still exhibit a minor visual defect after gluing, but this is purely aesthetic.
Only one piece of each type is needed, except for the 'Feet' of which you will need 4.
=> The 'Feet' to the 'Base for Feet.'
=> The 'Holder for the Circuit Box' to the 'Circuit Box.' Be cautious during this step, as one of the pillars is hollow to allow wire passage, and the box has a compatible hole.
=> The 'LED Box' to the 'Circuit Box.' I recommend doing this assembly after installing the LEDs.
I do not recommend gluing other parts; this will allow for maintenance and cleaning.
The design is compatible with a 92mm fan.
The design wasn't intended to be hung, but I've had positive experiences tying fishing lines to the feet and interweaving them with the pillars of the 'Holder for the Circuit Box.'
The feet still exhibit a minor visual defect after gluing, but this is purely aesthetic.
Only one piece of each type is needed, except for the 'Feet' of which you will need 4.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
