Thingiverse
Fly swatter
door j3dcnc
0
Downloads
0
Likes
0
Makes
Use a coat hanger and make a fly swatter
Cut the top of the hanger off, straighten, fold in half then stick through and bend the tips to hold at the top
There is a 3mf that you can use with the modifier already done. Otherwise load the swatter and then use the modifier and set the modifier to 0 top and bottom layers and choose the infill you desire.
Cut the top of the hanger off, straighten, fold in half then stick through and bend the tips to hold at the top
There is a 3mf that you can use with the modifier already done. Otherwise load the swatter and then use the modifier and set the modifier to 0 top and bottom layers and choose the infill you desire.
j3dcnc publiceert ook op
30 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
