Flying Scooters Working Model

This is a model of the Larson Flying Scooters you might see at some parks around the world. This was not taken directly from Larson, but based off of publicly available information.
This is for a functional model with a motor that can be found here: https://www.amazon.com/NW-Planetary-Reducer-Torque-Gearbox/dp/B07DCLL82G although it's a slightly different motor, just cut off the tabs. If you want a static model that you can still turn follow the instructions at the tile section.

Below are a list of the pieces and how many of each you'll need to print:

FS ground tile.stl
These are the pieces that will surround the ride and act as the ride platform. These are puzzle like pieces. Print 10 of these flat. If you're just making a model without the motor, print 12 and ignore the next 2 pieces.

FS channel R ground tile.stl
This is a specialized tile to allow for 2 wires to travel under the platform into the center to power the motor. This piece goes to the right of the wire. Print