Flying Tourbillon Model III

I was dissatisfied with Model II, so here is a better example for #teamplanetary. It uses the same basic mechanics but offset to the side for a more compact, albeit taller overall package. Another difference from the previous two efforts is that this is a 20 second tourbillon rather than a 60 second version. This means that this model actually meets my original goal of being ID tag powered. I do not think this one is as accurate as version 1 (depicted above) due to the tourbillon cage not being perfectly balanced. Even so, it still ticks merrily away for just under a minute limited by the length of my ID tag chain.

frameb and the base require supports. 2mm pins hold the frames together and I added some PVA glue to help them out.

See it in action: https://www.youtube.com/watch?v=xE57NHKSKj8&feature=youtu.be

non-printed parts:
2 x 6x2.5x3 RC Helicopter ball bearings
2 x 25mm long 2mm shafts (escape and
2 x 16mm long 2mm shafts (frame pins)
1 x 19mm long 2mm shaft
1 x