Thingiverse
Flying Yeti
von Charlie1982
235
Downloads
208
Likes
3
Makes
This is the Yeti add Victory's wing.
--------------------------------------------------
Fully with strong and easy clean up support.
This is very interesting for me to put those things together.
Hope you will like it :D
When you going to print this, layer high 0.15~0.25mm should be fine raft is better to use and best to use over 5% infill.
Check out more cool design on
http://www.ddf3d.com/
Enjoy ;)
--------------------------------------------------
Fully with strong and easy clean up support.
This is very interesting for me to put those things together.
Hope you will like it :D
When you going to print this, layer high 0.15~0.25mm should be fine raft is better to use and best to use over 5% infill.
Check out more cool design on
http://www.ddf3d.com/
Enjoy ;)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
