Thingiverse
FLYINGBEAR GHOST 4S - FRONT PLATE
di RIC967
1
Download
1
Likes
0
Makes
This is a cover for the heated bed of the Ghost 4S.
It is purely aesthetic in order not to see the bad insulation under the bed.
Printable without supports or anything else, the only change to make is to decide the length of the piece.
It is now 20mm, the one in the photo is 230mm ... you can reach the maximum size, if you print in diagonal, at your discretion.
To put it on the bed, you have to dismantle one of the two side screens.
It is purely aesthetic in order not to see the bad insulation under the bed.
Printable without supports or anything else, the only change to make is to decide the length of the piece.
It is now 20mm, the one in the photo is 230mm ... you can reach the maximum size, if you print in diagonal, at your discretion.
To put it on the bed, you have to dismantle one of the two side screens.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!