Thingiverse
FlyingBear Tornado 2 pro Fan + adjustable height
por VladKon
23
Descargas
26
Likes
0
Makes
Only for TORNADO 2PRO
This part allows you to cool the model.
It does not reduce the printing area.
This part requires gluing of 2 pieces and a radial fan 5025 (24 V).
A large slot is required for installing screws and adjusting the height. However, it should be closed for work with scotch tape.
NOTE 1! ONLY FOR VOLCANO heater !!! (not standard)
top_obduv1.STL
Bottom_obduv1.STL
ONLY FOR VOLCANO heater !!!
NOTE 2! NOT tested YET!!! (ok for Standard heater)
top_obduv2.STL / 2.STEP
Bottom_obduv2.STL / 1.STEP
with adjustable height for standard and other heaters
This part allows you to cool the model.
It does not reduce the printing area.
This part requires gluing of 2 pieces and a radial fan 5025 (24 V).
A large slot is required for installing screws and adjusting the height. However, it should be closed for work with scotch tape.
NOTE 1! ONLY FOR VOLCANO heater !!! (not standard)
top_obduv1.STL
Bottom_obduv1.STL
ONLY FOR VOLCANO heater !!!
NOTE 2! NOT tested YET!!! (ok for Standard heater)
top_obduv2.STL / 2.STEP
Bottom_obduv2.STL / 1.STEP
with adjustable height for standard and other heaters
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!