Flymo blade spacer washer

This is the spacer from a Flymo 300 series mower which allows the blade height to be set. When you bought the mower there were a stack of them which you removed and subsequently lost. Mine is a 330VX.

Also listed here is a hand grip to remove the bolt that screws the blade onto the shaft. You'll have lost the wrench that came with the mower and you could just use pliers but the bolt head is plastic and you'll chew it up. If you have a 34mm socket, just use that otherwise print this.

I printed the grip in PLA, orientated it on the bed with the hex upwards so no supports required. I'd defo use a brim and optionally use supports if you think the curve is too much. It wasn't for me but you know your own printer... I've oversized it slightly to allow for shrinkage.

The spacers - I printed these in ABS but anything will do. I know they'll degrade through moisture ingress and I'll be reprinting them again at some point. I suspect PETG is a better choice. Very happy to be educate