Thingiverse
Flysky I6S Gimbal Mount
von Mbouhabib1
1
Downloads
2
Likes
2
Makes
Hello! Thanks for downloading my I6s Gimbal Mount! Its a simple design and made for my gimbal (Zhiyun Crane M2)
might work on other gimbals.
Assembly is straight forward. Mount the base to the radio adn the front clip to the base with a screw and nut.
The inner diameter of the rear ring is 29mm. This is meant for the tripod leg attachment to slide into.
You can adjust this piece to match your gimbal. Plastic weld or CA glue the ring to the rectangular
block on the base.
I DO NOT recommend tilting your radio down while the gimbal is in place, there is a chance it could slide out.
might work on other gimbals.
Assembly is straight forward. Mount the base to the radio adn the front clip to the base with a screw and nut.
The inner diameter of the rear ring is 29mm. This is meant for the tripod leg attachment to slide into.
You can adjust this piece to match your gimbal. Plastic weld or CA glue the ring to the rectangular
block on the base.
I DO NOT recommend tilting your radio down while the gimbal is in place, there is a chance it could slide out.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!