Thingiverse
flysky jr module
von BadDesigner
6
Downloads
7
Likes
0
Makes
when the flysky i6 is hanging on the neckstrap, the module transmitter antenna is pointing upp,
With a short S-Video cable you can plug it in and take it out again
simply place 2 velcro straps on the back of the flysky
there is a pinplate with the files, connect some pins (+,- and ppm), pusch them trouh the plate on the right possition then place the plate with the pins in the jr module, place the jr module in the housing and hotglue the pinplate add the housing.
i used a 6v bec and a xt60 conector for powering the jr module, in combination with a lipo
xt60 connector: https://www.banggood.com/AMASS-XT60E-M-Mountable-XT60-Male-Plug-for-RC-Drone-FPV-Racing-p-1238483.html?rmmds=search&cur_warehouse=CN
With a short S-Video cable you can plug it in and take it out again
simply place 2 velcro straps on the back of the flysky
there is a pinplate with the files, connect some pins (+,- and ppm), pusch them trouh the plate on the right possition then place the plate with the pins in the jr module, place the jr module in the housing and hotglue the pinplate add the housing.
i used a 6v bec and a xt60 conector for powering the jr module, in combination with a lipo
xt60 connector: https://www.banggood.com/AMASS-XT60E-M-Mountable-XT60-Male-Plug-for-RC-Drone-FPV-Racing-p-1238483.html?rmmds=search&cur_warehouse=CN
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
