FMF Neon Sign

When Sliced at 0.2 layer height, you will need to add a change filament command. This can be done in the slicer on the RH side of the screen at the layer height slider in the preview tab. Start the print with black filament. You’ll use this until the first color changeAt layer height 13.20mm, you’ll want to swap to the color yellow.At layer height 15.20mm, you’ll want to swap to the color RED Part 1 will take roughly 5hrs depending on your speed/settingsPart 2 will take a pinch over an hour depending on settingsPart 3 will take roughly 5hr depending on settings I recommend using Hilbert curve for your top layer. This gives it a neat textured appearance. I also suggest 4 walls minimum along with 5 top and bottom layers to ensure a nice clean print. You can set infill to whatever design pattern you wish at about 10% density. Make sure you turn off single wall on first layer. This will ensure better bed adhesion. To assemble the model, you’ll need to lay the parts face down on a soft rag