FMG-9 Cover Latch Assembly

Replacement cover latch assembly parts for the Maruyama & Aegis FMG-9.

Drawn based off measurements for the Maruyama FMG-9, the 3d printed replacements drop right on in to both Maruyama and Aegis frames (i believe they are both VFC based). because the Aegis frame can use different slides, i have omitted a detail on the Latch sled that rides along the Maruyama's extended barrel to avoid jams when pulling back the slide. Additionally, as i needed a rod in addition to the rear cover latch, instead of a small roll pin, mine uses a 2.5x4mm set screw. if these details are required for your application i can add that upon request.

incase you are missing the other parts of the assembly you will need:
2.5 x 4mm Set Screw
3.5mm x 150 Steel Rod (i used a carbon fiber rod cause thats what i had lying around and it worked fine)
2.25 x 6mm roll pin
5.5mm O.D x 115mm 0.65mm Wire spring