Thingiverse
Foam Dart Cutting Jig
0
Downloads
0
Likes
0
Makes
Foam dart cutting jig for 58mm darts.
For the Biu Blaster 30" shell ejecting dart blaster shotgun. Similar to the UDL XM1014 and derivatives but slightly different dimensions.
https://www.amazon.ca/dp/B0DLT1SQQF?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Listed here as a remix but I found it easier to design from the ground up than modify Jurikles' model (because I'm dumb).
To be used with standard length foam darts
- Slide them in from the closed end until the rubber tip touches the plate
- Use a thin blade (ex. box cutter) to repeatedly and gently slide through the channel until you feel the blade cut through the foam
- Discard the cut piece and pop the rubber ended part out
For the Biu Blaster 30" shell ejecting dart blaster shotgun. Similar to the UDL XM1014 and derivatives but slightly different dimensions.
https://www.amazon.ca/dp/B0DLT1SQQF?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1
Listed here as a remix but I found it easier to design from the ground up than modify Jurikles' model (because I'm dumb).
To be used with standard length foam darts
- Slide them in from the closed end until the rubber tip touches the plate
- Use a thin blade (ex. box cutter) to repeatedly and gently slide through the channel until you feel the blade cut through the foam
- Discard the cut piece and pop the rubber ended part out
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
