Foam Ripper

Here is my attempt at the cheapest CNC foam cutter that can be built for the home shop. It was inspired by Alted's Low Rider and djk4linux's needle cutter.
Assembly instructions and a parts list is at https://www.flitetest.com/articles/another-cnc-foam-board-cutter.
My plates were milled from 3/4" HDPE that I found, but plywood should work. My wheels are 69 mm diameter from an old pair of rollerblades. The plate needs to be adjusted for different size wheels. X_Carriage_Plate.dxf is for 69mm wheels, and X_Carriage_Plate1.dxf is for 60mm wheels.
The z-axis rails are 5/16" x 8" bolts or 8 mm rods. The bearings are 608zz. The Y-axis tubes are 3/4" conduit.
The slots in the plates allow for a table between 3/4" and 4" thick. I am using a 32" door and get 24" x 69" of cut area. The tubes can be adjusted from a single sheet of foam for a waste board up to a 30 mm thick vacuum pad.
More details to follow...

This cutter was developed from ideas on the Flite Test Forum http://forum.flit