Fogo bin holder

When you print it make sure to print it on its side as shown in the slicer photo I uploaded, it's important that it prints standing up as to place the layer lines away from any of the directions that force will be applied to the holder, it prints perfectly fine standing up provided you give it enough of a brim. I would also suggest 3-4 walls and to NOT use arachne wall generation as the print in place spring just works better with classic. Known supported FOGO binsRockinghamThis bin works for Rockingham FOGO bins, I am assuming my local council didn't source their own bins so maybe other places around Australia will have the same bin, if your not from the Rockingham area and this fits your bin please let me know so I can update the listing Boost Meany support is appreciatedPartsAny screw that fits should do, but I used a 6g 18mm countersunk timber screw (I think it was this one: https://www.bunnings.com.au/zenith-6g-x-18mm-stainless-steel-long-thread-countersunk-head-timber-scr