Thingiverse
Foil Track Ruler Stencil
9
Downloads
6
Likes
0
Makes
This is a stencil to help you stencil one inch ruler to bottom of a foil board. useful for Kitefoil, SUPfoil or Wingfoil boards.
Two versions, due to 2 fonts.
Use painters tape to hold it in place and a larger piece of paper, perhaps paperbag or wrapping paper to block overspray from board.
I used PET but PLA most any material is good.
Infill was 15% but since it's so thin, infill might not even get used.
Layer height was 0.26 I believe. I used brim to help hold it to bed but I think that's not necessary unless you notice warping.
Two versions, due to 2 fonts.
Use painters tape to hold it in place and a larger piece of paper, perhaps paperbag or wrapping paper to block overspray from board.
I used PET but PLA most any material is good.
Infill was 15% but since it's so thin, infill might not even get used.
Layer height was 0.26 I believe. I used brim to help hold it to bed but I think that's not necessary unless you notice warping.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
