Thingiverse
foldable and adjustable Tablet PC Stand
von Ijon
69
Downloads
81
Likes
1
Makes
Suitabe for all Tablet PCs not thicker than 15mm
Designed for ExoPC Slate, fits also for WeTab
The Stand is adjustable in its angle. 5 Steps between 80° and 30°
On the Pictures is only one Stand visible. Currently I have only one finally assembled, because I lost some parts between printing and assembling.
If you print the File once, than you get enough Parts for two of them. One Stand only is to instable for a tabletcomputer.
Oh, and there was some HEAVY warping during print. I managed to assemble the Part, but it doesnt look very fine. I will print that Thing again, as soon as we have a HPB in c-base
Designed for ExoPC Slate, fits also for WeTab
The Stand is adjustable in its angle. 5 Steps between 80° and 30°
On the Pictures is only one Stand visible. Currently I have only one finally assembled, because I lost some parts between printing and assembling.
If you print the File once, than you get enough Parts for two of them. One Stand only is to instable for a tabletcomputer.
Oh, and there was some HEAVY warping during print. I managed to assemble the Part, but it doesnt look very fine. I will print that Thing again, as soon as we have a HPB in c-base
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
