Foldable Crib (Cribbage) Board

After being introduced to cribbage recently, I printed another designer’s board. It was ok, but since I don’t have an AMS, I was not able to print colored paths. It also was missing the starting and ending holes. Unfortunately the designer did not have access to change it, so I designed this board from scratch specifically designed for those of us without an AMS – or wanting to save filament with entire layers with one color. I also designed it to be printed without supports since they were almost impossible to remove cleanly. The result of half a dozen test prints is a foldable board that holds cards and pegs when closed, 8mm x 2mm embedded magnets to hold it closed and 4 separate layers of color. There are “dotted lines” between the holes for the colors allowing it to be printed upside down without supports. Since this is from scratch, if anyone wants changes, I can do it for you pretty quickly. Since there are a lot of settings that have been adjusted to get this to print well, this