Thingiverse
Foldable guitar neck stand
door Vijit
2
Downloads
1
Likes
0
Makes
I think it's better to watch it once than to read it several times. So, watch [the video](https://youtu.be/ey2-6yjQCpE) about this thing.
#### Updates
I increased the space for the nut in the spool (+1 mm in height) to use the nut with nylon. If you will use such a nut "in print", then pause at a height higher.
#### Not printed parts
As the legs you'll need a PVC tube OD=25mm. So, first print out `joint_test.stl` and measure it in the tube you have. If you need other diameters, then go to the source and change whatever you need in the configuration.
Screws: two bolts M5, two nuts in the spool. Piece of the same size bolt for rigidly position the spool halves.
Tip: fill the tubes with salt, it will significantly add weight.
#### Source
The source is [here](https://cad.onshape.com/documents/9201d42c1a8536ffa2bb6243/w/0daf9c055bcb8405a8cc8abc/e/8629133bdbc34ba0f6ba7b2d).
#### How to use my configurable models in OnShape
To get an access to the thing source yo
#### Updates
I increased the space for the nut in the spool (+1 mm in height) to use the nut with nylon. If you will use such a nut "in print", then pause at a height higher.
#### Not printed parts
As the legs you'll need a PVC tube OD=25mm. So, first print out `joint_test.stl` and measure it in the tube you have. If you need other diameters, then go to the source and change whatever you need in the configuration.
Screws: two bolts M5, two nuts in the spool. Piece of the same size bolt for rigidly position the spool halves.
Tip: fill the tubes with salt, it will significantly add weight.
#### Source
The source is [here](https://cad.onshape.com/documents/9201d42c1a8536ffa2bb6243/w/0daf9c055bcb8405a8cc8abc/e/8629133bdbc34ba0f6ba7b2d).
#### How to use my configurable models in OnShape
To get an access to the thing source yo
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
