Foldable Macbook Pro Stand

Printed on an Ultimaker 2 with 0.2mm layer height and 0.4 extrusion width in colorFabb_XT light grey and green.

This was designed for my Macbook Pro 15 Inch Retina from 2014.

MBP Stand: this file can be printed without support, I printed it with a small line in the middle that could easily be removed.

Both the MBP L Notch and MBP R Slot are printed laying flat on the build plate.

MBP L Notch: This file can be printed without support, do keep in mind that it is 250mm long and you need to figure out the correct position on the bed.

MBP R Slot: This file has to be printed with support and is also 250mm long, so keep in mind the position on the bed.

After printing all you need is the following:

4 x O-ring for M3
2 x M3 x 20 hex screws
2 x M3 lock nuts that are inserted in the MBP Stand part