Folgertech FT-5/FT-6 SOLID direct drive extruder mount

*this is a completed project. It is running successfully on my own printer and does not need any further refinement; however, I am open to modifications for the purpose of fitting other parts*

Anybody with an FT-5 or FT-6 knows how bad the original ACM extruder mount is. This piece was created in order to give more solid mounting to the Extruder assembly on direct-drive Folgertech FT series printers. In addition to this, it corrects some major problems with the original design. In particular, it mounts the gantry board with plastic clips instead of metal nuts/bolts. The bottom left nut carries a chassis ground and it overlaps an unpadded hot circuit on the board. If/when it arcs, it takes out your main board, all of you stepper drivers and you orange/rasp pi if you have one installed. I have confirmed at least one other case of this happening so check your printer! This extruder mount also gives more surface area for the Y homing switch to contact, rendering my reverse bowden guide