Folgertech FT-6 Bltouch Mount

This is a BLtouch mount for the folgertech FT-6 printer. This mount uses M3 Square nuts and M3X10mm screws to affix the holder to the gantry. Height of the bltouch is adjustable.

***UPDATE 31 JAN 2019 ***

Users in the folgertech facebook group were asking for a center hole to allow access to the offset adjustment screw. I have uploaded a version with this modification.

***UPDATE***

Now includes firmware. The firmware assumes the following:

Your using a reprap discount smart controller for the LCD
All axis is using A4988 drivers
BL touch is installed to servo0 pins with the WHITE/BLACK wires connected to the Z-MIN endstop pins

If your setup is different than this, change the appropriate settings in config.h