Thingiverse
Followers
von Trekmaster30
143
Downloads
68
Likes
1
Makes
Full kit of plug followers for locksmith/locksport contains:
1 small with flat edge for crimped cores
1 small for padlock cores
1 medium with groove and half moon
1 medium with groove and hollow end
1 large with groove and hollow end
1 stand to hold the followers
For good results print at 20% infill,3 walls, at .15 layers with a .04mm nozzle at 50mm/sec.
1 small with flat edge for crimped cores
1 small for padlock cores
1 medium with groove and half moon
1 medium with groove and hollow end
1 large with groove and hollow end
1 stand to hold the followers
For good results print at 20% infill,3 walls, at .15 layers with a .04mm nozzle at 50mm/sec.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
