Foot for 32x8 Diffuser Fastener

Designed to keep the 32x8 panel mounted on a diffuser (with the fasteners) free-standing.
Was initially meant to replace the middle fastener of each half, but I guess it can fit on any of the fastener slots. The wider the space between the feet, the more stable it is!

Screw holes are same as the fasteners - M3 screws. Length you'll need 10mm if you have a front diffuser panel (that is 2mm thick), or 8mm without the diffuser panel.

## Changelog

**v2**
- Widen screw space by 1mm (to 7mm)
- Thicken back support fastener by 2mm (to 4mm)
- Added tapered angle to back support to prevent flexing from wind

**v3**
- Lowered height by 1mm (was not published)

**v4**
- Added groove so that bottom layer of the diffuser frame would stay fitted to this foot