Thingiverse
Foot for small DIY Leveling table for casting
door siderits
7
Downloads
2
Likes
0
Makes
When pouring small flat silicone rubber mats that are used for assembling electronics, its important to have a level surface to set the casting container on top of. This project designed "feet" for a small leveling table.
It uses 4 leveling feet, washers, coupling nuts, springs and a flat piece of wood or Plexiglas.
1) Hot Glue 4 Elevating bolts to a flat piece of wood
2) Put a small tension spring on the threaded portion of each
3) Put a washer on top of the spring
4) Thread the coupling nut with the 3D printed foot on the elevating bolt
5) Turn it over and use a spririt level to level the surface for both front-back and left-right
6) Looking down on the surface, turning the foot clockwise - RAISES the corner.
It uses 4 leveling feet, washers, coupling nuts, springs and a flat piece of wood or Plexiglas.
1) Hot Glue 4 Elevating bolts to a flat piece of wood
2) Put a small tension spring on the threaded portion of each
3) Put a washer on top of the spring
4) Thread the coupling nut with the 3D printed foot on the elevating bolt
5) Turn it over and use a spririt level to level the surface for both front-back and left-right
6) Looking down on the surface, turning the foot clockwise - RAISES the corner.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
