Foot pedal

Hi, I designed this foot pedal for spot welder, but you can use for any use...
Printed with PLA 25% infill, 6 walls. Support need only for top piece. Hole for cable is 5mm. Added holes for tight cable with cable ties (2x slot 2x8mm )
Dimensions: 100 x 60 x 45mm

Hardware:
pin - 4x60 or bolt M4x55 + M4 nut
bolt 2x M3x10 + 2xM3 nut
bolt M2,5x12 (or if you make thread in switch, you can use bolt M3x10. Switch have 2,5mm hole)
microswitch - standard 20x10x6 limitswitch witch roller https://aliexpi.com/CpGF

spirng: https://aliexpi.com/HstA (or any simillar with 40-50 length and 10mm diameter)
length: (40) 50,
outer diameter: 10mm
wire diamenet: 0.7mm

2x cable tie

I'm not designet, but I hope will be useful for you. If you use, make a post or comment.

You can share freely with link.