Thingiverse
Footswitch interface case
par TheObstacle
5
Téléchargements
1
Likes
0
Makes
This is a case for a USB footpedal interface I made. The Arduino code is here: https://github.com/monroewilliams/footpedal
It's intended to hold a mini breadboard (with a hole exposing the USB port on a microcontroller plugged into the board) and a variable number of 1/4" panel-mount TS or TRS jacks.
The number of jacks is configurable in the OpenSCAD file via the `jack_count` variable. If you set the number of jacks below two, the breadboard won't fit anymore.
The `usb_h` and `usb_v` variables set the location of the hole for the USB jack, you may have to fiddle with the numbers to line it up with the plug on your breadboard/controller combo.
I didn't add any specific features to hold the lid closed, but in my prints it stays on quite well as just a friction fit.
It's intended to hold a mini breadboard (with a hole exposing the USB port on a microcontroller plugged into the board) and a variable number of 1/4" panel-mount TS or TRS jacks.
The number of jacks is configurable in the OpenSCAD file via the `jack_count` variable. If you set the number of jacks below two, the breadboard won't fit anymore.
The `usb_h` and `usb_v` variables set the location of the hole for the USB jack, you may have to fiddle with the numbers to line it up with the plug on your breadboard/controller combo.
I didn't add any specific features to hold the lid closed, but in my prints it stays on quite well as just a friction fit.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
