Thingiverse
ForceFighter Adapter v1.0
di ZZCheetahZZ
5
Download
4
Likes
0
Makes
This is used to connect the CH Fighterstick grip to the Microsoft Sidewinder Force feedback II (MSFF) joystick base.
You suppose to disassemble the MSFF's grip and cut down the plastic adapter that's left to a minimum of about 2 mm.
First, wire the USB cable through the ForceFighter adapter (needs to be cut and re-connected afterwards).
Next, the printed ForceFighter adapter should be covered with Epoxy on its lower shaft and inserted into the MSFF base while holding it straight and aligned with your new Fighterstick grip and MSFF base.
You suppose to disassemble the MSFF's grip and cut down the plastic adapter that's left to a minimum of about 2 mm.
First, wire the USB cable through the ForceFighter adapter (needs to be cut and re-connected afterwards).
Next, the printed ForceFighter adapter should be covered with Epoxy on its lower shaft and inserted into the MSFF base while holding it straight and aligned with your new Fighterstick grip and MSFF base.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
