Slicer Discord
Ford Focus Catch Cable Clip – 3D-Druckmodell von Thingiverse Thingiverse

Ford Focus Catch Cable Clip

von buddy1477
2 Downloads
2 Likes
0 Makes
Zum Modell
Should work on all Ford Focus' 2004 -2011.

Problem: Usually when you turn your key to the left and then the right your hood latch should open up. When it doesn't its because this part (with good intentions to fight against tampering) sheers or tears and doesn't make contact with the locking end. This part should be easy enough to pop in and get you going. 5 pound part on ebay thats part of a 40+ pound assembly that could cost 80+ just to install. Give it a shot before you end up paying far more than you need to.

Print horizontally so the sheer forces go against the layer lines.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen