Thingiverse
FordEdgeClips
18
Downloads
6
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hO03kdXYThL
I just bought a 2017 Ford Edge and at 65MPH on a windy day I noticed a loud vibrating sound from the bottom of the car. There is a splash shield under the car that runs on both sides from front axle to back axle. When I would move that with my hand I noticed it sounded very loud and loose in the middle. (I tested a 2015 for this issue and it was tight) So I figured mine just had worn out mounting clips. I printed these clips to fill the gap between the Ford mounting clip and the shroud. I hope this helps and will report back the results if the sound goes away.
THE SOUND DID GO AWAY!
I just bought a 2017 Ford Edge and at 65MPH on a windy day I noticed a loud vibrating sound from the bottom of the car. There is a splash shield under the car that runs on both sides from front axle to back axle. When I would move that with my hand I noticed it sounded very loud and loose in the middle. (I tested a 2015 for this issue and it was tight) So I figured mine just had worn out mounting clips. I printed these clips to fill the gap between the Ford mounting clip and the shroud. I hope this helps and will report back the results if the sound goes away.
THE SOUND DID GO AWAY!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
