Formbot E3D Titan & E3D V6 adapter

This is an adapter to run the Titan extruder and the E3DV6 on the Formbot T-Rex 2+

The Titan extruder should be the "mirrored version" for the left extruder and regular version for the right extruder. If this is not done the gear will overhang on the wrong side and foul on the opposite extruder.

Source Code will need to be modified to rotate the extruder in the opposite direction.
See the E3D manuals on what needs to be changed for the titan and the V6, the Formbot uses marlin firmware. There is only 1 INO file in the Formbot source code, open this with the Arduino IDE. The steps/mm are set at 405.5 instead of 92.5 with this new system due to the 3-1 reduction and smaller filament gear/drive.

Bottom of the carriage will need to be cut to allow for the shorter length of the E3DV6

Formbot circuit board will need to be modified by removing the plug on the circuit board that goes in the motor, and soldering a plug with a lead instead. I just soldered the wires from a standard