Fountain Bird Bath

You can print most of those with resolution 0.2, but I recommend 0.12 for the sink and casing.
Supports are needed for the pool and casing.
I used PLA at 200 degrees, but PET might be even better.
I left FreeCad file for you to edit to your needs.
Make sure you set it properly for it to be water resistant and don't use toxic materials.
The 12V pump I used is a bit too powerful, so I use it at 7.5V and pushed a little bit of sponge into the hose to lower the pressure. You can use 6V pump for this.


I used:
-12V water pump: https://shorturl.at/eoJZ5 (you may want to consider lower power pump)
-DC 5.5x2.1mm socket: https://shorturl.at/eHRV1
-Power switch: https://shorturl.at/pABH7
-8mm hose
-12V DC power supply (in my case regulated 3-12V)
You can add a fuse for safety and seal the electronics part off with aquarium glue.

Post your print and let me know if your bird likes it! :)