Fountain Pen Rest

I wanted to learn a bit of CAD and 3D printing so I designed a fountain pen holder as one of my main hobbies. There may be a few wonky settings with scaling. The part is supposed to be in CM with the base (the flat part without the cross-section through the middle) being 12 by 12. If I were to print this again I would likely try to place some supports under the top where I had my name. When it finished printed this had some bits of the ABS stringing down. Also be aware that I printed this 90 degrees rotated to how the file originally shows it with the thicker cross sections being the base.