Thingiverse
Fountain top
von remkon
1
Downloads
2
Likes
0
Makes
This is a 2 piece fountain top (cat not included) that I created for the pump in my small waterdish pond.
The pump I purchased generated to much flow and the fountain parts that came with it were to tall and generated to much noise so I decided to build my own fountain top.
As I like the dome fountains I treid to make that, the head is a bit large but it needed to fit our pondcat
printed it in PETG, didnt need to glue the top to the bottom but you can if you want to.
The tube diameter is 23mm to fit needly into the 24mm tube that came with the pump.
The top is 100mm diameter.
Can be printed without supports.
The cat that's guarding my pond is the Fat Cat by pmoews
The pump I purchased generated to much flow and the fountain parts that came with it were to tall and generated to much noise so I decided to build my own fountain top.
As I like the dome fountains I treid to make that, the head is a bit large but it needed to fit our pondcat
printed it in PETG, didnt need to glue the top to the bottom but you can if you want to.
The tube diameter is 23mm to fit needly into the 24mm tube that came with the pump.
The top is 100mm diameter.
Can be printed without supports.
The cat that's guarding my pond is the Fat Cat by pmoews
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
