Thingiverse
FOUR PLAYER MANCALA BOARD
por davidmhull
4
Descargas
1
Likes
0
Makes
Wanted to play mancala with the entire family.
Print four pieces on a large printer (300x300 recommended) to complete the board or scale it down for a smaller printer. The hollow areas are to reduce material usage and printing time.
The notches need support, to mate with the quick assembly fingers.
Once completed, the board is 16"x16" across. It took me over 23 hours to print each quarter at 60-70 mm/sec at 0.2mm layer height.
Print four pieces on a large printer (300x300 recommended) to complete the board or scale it down for a smaller printer. The hollow areas are to reduce material usage and printing time.
The notches need support, to mate with the quick assembly fingers.
Once completed, the board is 16"x16" across. It took me over 23 hours to print each quarter at 60-70 mm/sec at 0.2mm layer height.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
