Four Shafts Table Loom

This table loom uses 4 shafts or frames to allow you to weave a large number of patterns, over a maximum width of around 40 cm. But you can start with narrower fabrics.
I decided to take on this project because I hadn't found any looms with movable frames that would meet my needs.
Before making it, you must read the description (.pdf file) carefully. It takes a long time to 3D print...and you can't print all the parts. You will also need some wood work.

The 3D design was done using FreeCAD. Should you which to modify / improve parts, just contact me so that I can provide the corresponding .FCStd files.

I hope that you will enjoy it as much as I did!

NB: files were updated on November 08, 2024