Slicer Discord
Four tone whistle – 3D-Druckmodell von MakerWorld MakerWorld
Other Hobby & DIY

Four tone whistle

3 Downloads
0 Likes
0 Makes
Zum Modell
all credit goes to SelfTaughtStu_472555 This whistle design was born from my experiment with a 3D-printed whistling bomb, intended to be dropped from a drone. I took inspiration from the "Whisbang RC whistling bombs" and created a body with four chambers, hoping each one would produce interesting sound during free fall. Unfortunately, even from a 500m drop, it didnt produce any sound. However, when used like a traditional whistle (blowing into it) it works and its very loud, so I redesigned it to be a whistle instead. Using the Spectroid Android app, I measured the frequencies and loudness of each tone. Based on spectrum analysis assisted by ChatGPT, the results are approximately: 2769 Hz at -34 dB 3393 Hz at -31 dB 4447 Hz at -25 dB 6211 Hz at -18 dB I wasn't even blowing very hard during the test, since the sound was already quite intense. With more forceful blowing, it could likely get much louder. While 6211Hz was technically the loudest in the spectrum (at -18 dB), it sounded low
Kategorie
Other Hobby & DIY
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen