FPV 250/300

I have completely upgraded the r.250 FPV Quad by quadmodder. I fly my quad fast and crash hard. I was tired of the same parts breaking in the same locations. I also increased the width of the body so I could put all four ESCs on top of the bottom plate to protect them. The width addition brings this quad in at just under 300mm. I added a frame around the perimeter to reduce frame twist, I also added gussets to the screw holes that had the highest failure rate. The arms have been redesigned to maximize strength and reduce twist. I have not broken an arm since this modification.

I used to use PET to make this quad for increased strength and dimensional stability, but since I made these changes to the frame I have switched back to ABS. ABS prints just as well for me on my PowerSpec 3D Pro (OEM FlashForge Pro).